Draytek Vigor2760Vn Guide d'installation télécharger pdf (Page 20)

Vigor2760 Series Quick Start Guide

The WAN2 port supports connections where there is Ethernet presentation

from the ISP supplied modem or Internet connection instead of xDSL.

WAN2 uses the physical port normally designated as LAN4.

If WAN2 is used then WAN1 will be disabled and vice versa. To setup the

Vigor 2760 to connect via WAN2 then please follow the steps below:

1. Open WAN >> General Setup.

2. Click the WAN2 link to open the following page:

3. Enable WAN2 (Enable:Yes), give the connection a display name (e.g.

your ISP’s name) and click OK to save and exit.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Pas de commentaire

Draytek Vigor2760Vn Guide d'installation Page 20