Draytek Vigor 3200 Series Guide d'installation télécharger pdf (Page 15)

Vigor3200 Series Quick Start Guide

This section will guide you to install the router through hardware connection and

configure the router’s settings through web browser.

Before starting to configure the router, you have to connect your devices correctly.

1. Connect the cable Modem/DSL Modem/Media Converter to any WAN port of router

with Ethernet cable (RJ-45).

2. Connect one end of an Ethernet cable (RJ-45) to the LAN port of the router and the

other end of the cable (RJ-45) into the Ethernet port on your computer. Or, use a

switch to connect Vigor router and computer(s).

3. Connect one end of the power adapter to the router’s power port on the rear panel,

and the other side into a wall outlet.

4. Power on the device by pressing down the power switch on the rear panel.

5. The system starts to initiate. After completing the system test, the ACT LED will

light up and start blinking.

(For the detailed information of LED status, please refer to section 1.1.)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 36 37

Pas de commentaire

Draytek Vigor 3200 Series Guide d'installation Page 15