Draytek Vigor2930 Series Guide d'installation télécharger pdf (Page 12)

Blinking The data is transmitting.

On The port is connected with 100Mbps. Right LED

(Green)

Off The port is disconnected with 10Mbps.

Interface Description

Factory Reset Restore the default settings.

Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for

more than 5 seconds. When you see the ACT LED begins to blink rapidly than

usual, release the button. Then the router will restart with the factory default

configuration.

Restart Restart the router forcefully.

Phone (1/2) Connecters for PSTN phones.

ISDN S0 1 Connecter for ISDN phone(s) only via ISDN phone adapter. Do not connect any

other device to such port or connect ISDN line, otherwise the router might be

damaged.

ISDN S0 2 Connecter for ISDN line or ISDN phone adapter in particular condition. Refer to

section 2.2 for more details.

WAN (1/2) Connecters for remote networked devices.

LAN (1-4) Connecters for local networked devices.

PWR

Connecter for a power adapter.

ON/OFF

Power Switch.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Draytek Vigor2930 Series Guide d'installation Page 12