Draytek VigorAP 700 Manuel d'utilisateur télécharger pdf (Page 13)

Chapter II: System and Network Setup

2-1 Installing VigorAP 700 to your Network

Please follow the following instruction to build the network connection between your new

VigorAP 700 and your computers, network devices:

1. Connect VigorAP 700 to ADSL modem, router, or switch/hub in your network through the

LAN port of the access point by Ethernet cable.

2. Connect a computer to ADSL modem, router, or switch/hub. Make sure the subnet IP

address of the PC is the same as VigorAP700, e.g., 192.168.1.X.

3. Connect the A/C power adapter to the wall socket, and then connect it to the PWR connector

of the access point. Power on VigorAP and check all LEDs on the front panel. PWR LED

should be steadily on, LAN LEDs should be on if the access point is correctly connected to

the ADSL modem, router or switch/hub.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 64 65

Pas de commentaire

Draytek VigorAP 700 Manuel d'utilisateur Page 13