Draytek Vigor VigorAccess Guide d'installation télécharger pdf (Page 34)

VigorAccess Installation Guide

Before you purchasing the device, please check your environment to determine which

power type that matches with your requirement.

The AC input and ground connections can be done on the rear panel. You can connect the

rack to ground by using spring screws.

1. Connect the female end of the power cord to the power socket on the rear panel of

VigorAccess.

2. Connect the other end of the cord to a power outlet and make sure that no objects

obstruct the airflow of the fans (located on the rear side of the unit).

The DC input and ground connections can be done on the rear panel. You can connect the

rack to ground by using spring screws.

1. Check and ensure that power in the DC source is OFF.

2. Remove the cover of the DC power connector.

3. Connect chassis ground to stud terminal labeled “FG”.

4. Connect the power lead from the positive terminal of power source to the stud

terminal labeled “RTN”.

5. Connect the power lead from the negative terminal of power source to the stud

terminal labeled “(–) 48VDC”.

6. Put back the small plastic cover over the power terminals.

7. Check and turn on the power from power source. If the power is properly connected,

a PWR green LED on the front panel of VigorAccess lights up.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 44 45

Pas de commentaire

Draytek Vigor VigorAccess Guide d'installation Page 34